Filling mowing heads - TrimCut 31-2
The TrimCut mowing head has a line storage device, but the line must be fed manually. The line may only be fed out when the engine is switched off. To do this, the screws on the mowing head must be loosened and the lines pulled out manually on both sides.
The line may only be replaced when the engine is switched off.
Step 1 of 6: Remove the bobbin
Step 1 of 6: Remove the bobbin
Undo the screw on the mowing head by turning it clockwise and remove the bobbin.
Video
Filling mowing heads
TrimCut 31-2 - Step by step.
| Flash 14.9 MB |